Prior to installation

Notes:

1. Please ensure that the computer works normally and meets the minimum system requirement.

2. The current user of operating system must have the authority of system administrator.

3. SysFreezer can only protect all the partitions of the fist physical hard disk detected by BIOS. It can’t protect data of any other hard disks in the computer.

4. When installing SysFreezer Client, each recovery point initially occupies 0.05% continuous hard disk space. For instance, you want to install SysFreezer Client Program on a 250GB hard disk and support a maximum of 5 recovery points. Then the installation of SysFreezer will require at least [250GB x 0.05% x 5 = 640MB] continuous space.

Suggestions:

1. If an older version of SysFreezer or a similar recovery product from other manufacturers has been installed, please must remove it!

2. Before installing SysFreezer, it’s strongly recommended to perform “Scandisk” to check and fix hard disk error. Also please perform “Defragment” to defragment hard disk data. These two actions will enhance the efficiency of SysFreezer after it’s installed.

3. Scan the entire system for virus and make sure the system is not infected by any virus. Then temporarily disable anti-virus software. This is because few anti-virus software products may consider SysFreezer’s installation action a virus invasion.

4. CMOS setting

‧Disable the “Virus Warning” setting in CMOS.

‧Check the correspondence between the physical hard disk details and the hard disk parameters shown in CMOS. If any parameter is not correspondent, you have to access BIOS setting and verify the hard disk’s model and capability.

5. If the system uses a multi-boot tool, please ensure that the multi-boot program installed in the system doesn’t occupy MBR. If it does, you must remove the program; otherwise, the system might be affected after SysFreezer is installed.